54
m a n u a l o p e r a t i o n s
Recoater
The manual
Recoater
allows you to operate the recoater manually. The following pages show the
command’s functions.
Move:
Manually
moves recoater as the user specifies.
Home:
Moves the recoater motion axes to their home positions and redefines the home position
(relative zero position of the recoater).
End:
Moves the recoater to its rear limit.
Remove Bubbles:
Runs a pre-defined operation to remove bubbles on the resin surface.
Calibrate Recoater:
Runs a pre-defined operation to calibrate the recoater system.
Distance:
Specifies distance, in inches or millimeters, from current position; negative moves
recoater toward the front of the machine, positive moves recoater toward the rear of the machine.
To
Move
the Recoater forward or back,
specify
Distance
and
Velocity
.
70696 Revision 1C 27-Aug-08
