3D Systems Viper Pro SLA iPro 8000, Quick Start Manual

Page: 21 / 81

q u i c k s t a r t g u i d e r d m i n s t a l l a t i o n a n d r e m o v a l
21
In handling the RDM, please note that no resin that has been exposed to the RDM can be re-
introduced into the new resin supply container. The build platform can accommodate up to two
10kg resin supply containers. The RDM has an overflow compartment that also functions as a
reservoir for resin level control. This compartment contains any accidental dispensing of the full
10kg resin container without allowing overspilled resin. It can also capture resin surface debris.
An empty resin container can be used for overflow storage.
The manual valve, of 2 in. pipe, is the same shape as the bottom of the surface, which makes the
resin delivery module fully drainable. Therefore, there are no trapped volumes of liquid.
Table 1: Build Envelope, Maximum Part Size
There are two operating modes for the RDM:
Width (mm)
(left to right)
Depth (mm)
(front to rear)
Height (mm)
(top to bottom)
Small RDM 650 750 50
Medium RDM 650 750 275
Large RDM 650 750 550
Extra Large RDM 1500 750 500