q u i c k s t a r t g u i d e
r d m i n s t a l l a t i o n a n d r e m o v a l
16
RDM Installation and Removal
Installation
Before installing the Resin Delivery Module (RDM), make sure that the power is turned off.
Usually, the user needs only to install or remove the RDM when changing resin.
Assuming the RDM is outside the Viper Pro, the following steps describe how to install the RDM.
Irritant Hazard
Bodily irritation or allergic reaction can result if you ignore this type of hazard
message.
Before installing the module, note that the RDM is very heavy and may require more than one
person to remove or install it. While wearing protective clothing, disposable nitrile gloves, and
goggles, follow these steps:
1 Open the RDM door; roll the RDM to the side of the machine in which you want to place it.
2 Make sure that the connecting cables are out of the way of the RDM before you attempt to
place the RDM in the machine.
3 Make sure that the elevator is down before you move the RDM into the machine.
4 With a cleared path, push in the RDM until the locking pin located on the outer side of the
machine pushes up and then goes into place in the hole. (See Figure 1., “Locking Pin,” on
page 17) When the locking pin attaches properly, the RDM will also hit the bumper at the
back of the machine.
Summary of Contents for Viper Pro SLA iPro 8000
Page 2: ...q u i c k s t a r t g u i d e 2 Customer Support 78 Legal Notices 79 ...
Page 12: ...q u i c k s t a r t g u i d e q u i c k s y s t e m o v e r v i e w 12 ...
Page 13: ...q u i c k s t a r t g u i d e q u i c k s y s t e m o v e r v i e w 13 ...
Page 14: ...q u i c k s t a r t g u i d e q u i c k s y s t e m o v e r v i e w 14 ...