3D Systems sPro, User Manual

Page: 94 / 280

SLS p r o c e s s 9 4 B R E A K O U T P A R T S
u s e r ’ s g u i d e p o w e r - o n t h e B O S a n d d u s t c o l l e c t o r
Po we r - o n t h e B O S a n d D u s t Co l l e c t o r
BOS Power-up
1
Turn the BOS
POWDER
TRANSPORT
switch to OFF .
2
Turn the BOS
POWER switch on.
The BOS displays Initializing , then
Establishing network connection ...
L
The yellow stacklight lamp is on while the
BOS establishes a network connection. The
green light turns on when it does.
3
After about 15 seconds, the BOS displays
In Standby .
While In Standby , the air supply to the BOS is
off, all motors are off, and no powder is
transported.
Dust Collector Power-on
1
Open the Dust
Collector enclosure
and empty the
dust pail if
necessary.
2
Connect the
flexible duct pipe to the air duct flange on
the left or right outer wall of the BOS
chamber.
3
Turn on the power switch on the upper right
side of the Dust Collector cabinet.
Before you turn on the BOS, make
sure RCM cable is
NOT connected to
the RCM.
See BOS Operator
Controls and Indicators
on page 202 to locate
switches.
See the Dust Collector
Installation and
Operation
manual that
shipped with your
system.