3D Systems sPro, User Manual, Page: 55 / 280

SLS p r o c e s s
u s e r ’ s g u i d e
P R E P A R E T O B U I L D
This section describes what you need to do before you can build parts in the SLS system. It
steps you through the following procedures:
`
Setting Up a Build Packet . . . . . . . . . . . . . . . 56
`
Cleaning and Checking Equipment . . . . . 59
`
Starting the Equipment . . . . . . . . . . . . . . . . 60
`
Unloading the IPC . . . . . . . . . . . . . . . . . . . . . . 65
`
Preheating the RCM . . . . . . . . . . . . . . . . . . . . 68
`
Docking the RCM in the SLS System . . . . . 69
`
Pre-Build Checklist . . . . . . . . . . . . . . . . . . . . . 70
`
Verifying Sufficient Powder . . . . . . . . . . . . . 71