3D Systems sPro, User Manual

Page: 51 / 280

SLS p r o c e s s 5 1 S L S P R O C E S S
u s e r ’ s g u i d e a b o u t i n s t a l l a t i o n a n d f a c i l i t y
r e q u i r e m e n t s
Ab o u t I n s t a l l a t i o n a n d Fa c i l i t y R e q u i re m e nt s
3D Systems certified service personnel install the
SLS equipment. Prior to installation, your
company receives specific facility requirements
and a pre-installation facility checklist from
3D
Systems.
For complete information, refer to the
`
SLS Process Facility Guide and
`
SLS Process Facility Layout
for sPro SLS
fmodels 140 and 230.
The pre-installation facility checklist must be
completed and returned to 3D Systems Customer
Support before you can schedule installation.
Connecting your network
The SLS system computer can be connected to
your existing TCP/IP (Ethernet) network.
However, if you connect the SLS system
computer to your network, do not use the
following IP addresses:
192.88.202.1
192.88.202.2
These addresses are used by the beam delivery
system. If this presents a problem, contact the
3D Systems Customer Support Hotline for
technical assistance.