3D Systems sPro, User Manual

Page: 176 / 280

SLS p r o c e s s 1 7 6 I R S & I P C
u s e r ’ s g u i d e I R S & I P C t r o u b l e s h o o t i n g
REACTIVATION AFTER IRS BIN WEIGHT ERROR
If the IRS detects an unexpected change in an IRS
bin weight (anytime other than during a powder
transfer), it will do the following:
`
Display Bin Weight Error...<deactivation
code> along with the 3D Systems’ Customer
Support phone number.
`
Send a message to the APMU to stop all
powder transfers.
After a Bin Weight Error , SLS system(s) can
continue to run until their feed hopper(s) are
empty.
To reactivate powder transfers, do the following:
1
Write down the displayed deactivation code.
L
If the error message is overwritten, press
repeatedly display and scroll the list of
recent IRS error messages.
2
Call the 3D Systems Customer Support
Hotline number to request a reactivation
code. You’ll be asked to provide the
deactivation code on your IRS display.
3
Follow the Customer Support
Representative’s instructions for entering the
reactivation code.
4
After you enter the code, navigate to the
Setup menu in either Standby or Ready
mode.
5
From the Setup menu, choose Reset Bin
Weight Errors , then press .
L
If you do not see the Reset Bin Weight
Errors option on the Setup menu, ask your
Customer Support Representative for
assistance.
After bin weight errors are reset, the IRS will
resume powder transfers when you put it in
Ready mode.
IRS Stacklight states
See IRS Stacklight on page 153.
No powder can be transferred until
the you reactivate the IRS and reset
the bin weights.