3D Systems sPro, User Manual

Page: 112 / 280

SLS p r o c e s s 1 1 2 R C M
u s e r ’ s g u i d e R C M s a f e t y
R C M S a f e t y
When you use any SLS equipment, follow all
general safety guidelines in Safety on page 9.
When you use the RCM, follow the guidelines in
this section as well. They are specific to the RCM
machines.
Follow these safety guidelines when operating
the RCM:
`
Read and follow all operating instructions.
`
Follow all safety rules in this section and heed
all hazard warnings in this guide.
`
Do not try to do any equipment maintenance
procedures you were not trained to do.
• Operators are trained to operate the
system and perform all the necessary tasks
to print a part.
• Certified service personnel are those
who have completed the 3D Systems
service training package and are certified
to perform service tasks. Certification may
occur at various levels, and servicers
should only perform tasks they are
authorized and certified to complete.
`
Use special caution when handling a heated
RCM and when dealing with the heated, inert
environment inside the SLS system’s process
chamber. Take note of all thermal hazard
warning labels on the machines.
`
Do not try to open any panel or door while a
machine is running.
`
Do not access any area of the machine near
the process chamber high-temperature-
material builds.
`
Do not use any material without first
reviewing its
Material Safety Data Sheet
(MSDS) .
`
Always disconnect the RCM cable before
moving the RCM out of the SLS system or
BOS .
`
Do not try to access, service, or adjust the
laser system in any way.
`
Do not enter any area displaying posted
warning signs during open beam operations.
Open beam operations refer to the laser, and
they only occur during service procedures.