3D Systems sPro, User Manual

Page: 100 / 280

SLS p r o c e s s 1 0 0 B R E A K O U T P A R T S
u s e r ’ s g u i d e s h u t d o w n b o s
S h u t d o w n B O S
Shutting down the BOS stops the following
operations:
`
Used powder transport to the IRS Used bin (in
RECYCLE mode)
`
Used powder transport to the waste drum in
(in
DISPOSAL mode)
`
Part piston motion (if and RCM is connected
and the part piston is being raised or
lowered)
`
Sifting
`
Network communications with other SLS
process machines
You must shut down the Dust Collector
separately. You can do this at any time by simply
turning off the Dust Collector’s power switch.
To shut down the BOS properly
1
If the BOS is currently transferring powder to
the IRS, wait until the BOS operator panel
says
Powder Xfer Complete .
2
Press repeatedly until the BOS operator
panel displays In Standby .
3
Turn off the POWER switch on the IRS
operator panel.
See IRS Operator Controls and Indicators on
page 133.