26
3D SYSTEMS, INC
.
PN:80-D27 Rev.B
A . Chamber door
The operator accesses the inside of the chamber through the two glove ports located on the front face of the machine .
The sliding door must be opened to access the glove ports (see section "Loading the feeding piston" on page 57) . Two
interlocks, on the sliding door and on the gloves door, block all movements (tamping module, carriage, etc…) .
The chamber is equipped with a laser safety window .
850nm≤λ≤1100nm DLB5 - IRLB8 - CE EN207
The door provides access to the entire chamber only for maintenance .
Only qualified personel may operate the machine with the chamber door opened
B . Manufacturing chamber
The direct metal printing takes place in the manufacturing chamber, which is kept under a controlled inert atmosphere
during the printing process .
The manufacturing chamber consists of :
1
LAYERING MODULE (SEE SECTION "1 . LAYERING MODULE" ON PAGE 27)
2
FEEDING PISTON (SEE SECTION "2 . FEEDING PISTON" ON PAGE 27)
3
SINTERING PISTON (SEE SECTION "3 . SINTERING PISTON" ON PAGE 27)
4
COLLECTING TANK (SEE SECTION "4 . COLLECTING TANK" ON PAGE 27)
5
FUMES CLEANER DEVICE (SEE SECTION "5 . FUME CLEANER DEVICE" ON PAGE 28)
6
HEATING ELEMENT (SEE SECTION "6 . HEATING ELEMENT" ON PAGE 28)
7
OXYGEN ANALYSER SENSOR (SEE SECTION "7 . OXYGEN ANALYSER SENSOR" ON PAGE 28)
8
POWDER TAMPING MODULE (SEE SECTION "8 . POWDER TAMPING MODULE" ON PAGE 28)
9
LENS CLEANER AND LENS TRAP (SEE SECTION "9 . LENS CLEANER AND LENS TRAP" ON PAGE 28)
10
VACUUM CLEANER (SEE SECTION "10 . VACUUM CLEANER" ON PAGE 28)
11
POWDER GUTTER (RECOVERY POWDER SYSTEM)
1
2
3
4
5
6
7
9
8
10
11