3D Systems ProX 950, Facility Requirements Manual

Page: 19 / 25

16 3D Systems, Inc.
APPENDIX B: PRE-INSTALLATION PREPARATION CHECKLIST
The following list helps you to prepare for your ProX 950. Prior to scheduling the installation appointment with a 3D Systems
representative, complete the checklist and fax it to your 3D Systems Customer Support Engineer.

Is there an adequately rated forklift available
during installation to move the equipment to its
destination?

Have you coordinated the move with your shipping
department?

Is there adequate doorway and hallway clearance
to move system components using available mov-
ing equipment?

Is adequate space available for the equipment and
supplies? (See “ Site Selection ” starting on Page 3)

Is the site prepared properly (according to the
“ S ite Selection ” on Page 3 of this guide)?

Are the following electrical power outlets in place?

For the ProX 950 : Do the electrical power
requirements meet the specifications in “ Site
Selection ” on Page 6 of this guide?

For service and other uses: Are there two ad -
ditional outlets, 110/220 V?

I n the room where the ProX 950 will be installed
does the air conditioning meet the following
requirements?

Is there a minimum cooling capacity of 3.6 kW
in the room ?

Is the temperature change less than 1°C
(1.8°F) per hour?

Is humidity maintained at an appropriate non-
condensing level for the resin (20-50%)?

Does the air change two to five times per
hour?

Is 10/100/1000BASE-T Ethernet network cabling
installed and in working order?

Is a cabinet available to store resin containers?

Does the room have a door that can be closed and
locked during installation?

Is there a network connection? (Optional)

Is there a telephone line? (Optional)
MOVING EQUIPMENT AND SITE ACCESSIBILITY

Is adequate space available for the equipment and
supplies? (See Space Requirements section on Page
9)

Is all construction to floors, ceilings, and walls
complete and does it meet local building code
specifications? Are floors clean and free of debris?
Are floors easily cleanable with solvents?

Have you decided what other equipment, acces -
sories, and supplies that you want to have with
the ProX 950 ? Have you decided on a location for
these items? (Refer to Figure 6 on Page 3)

Has a compressed air connection with a pres -
sure controller and fast closing connection been
installed? (Optional for parts finishing)

Is a workbench available that has negative pres -
sure and electricity for power hand tools?

Are electrical outlets and power available?

Is there a 110/220V outlet available for the Pro -
Cure UV Curing chamber?

Are there enough 110/220V outlets available in the
room for equipment and tools?

Have you installed the duct (if required) for ventila -
tion of the ProCure UV Chamber?

Is all the recommended safety equipment avail-
able, including nitrile gloves and wipes?
WASTE DISPOSAL AND SAFETY

Has a local waste disposal company been arranged
for periodic pickup of waste materials?
JOB SUBMISSION
(Workstations and Network Access)

Has 3D Systems software been loaded on at least
one workstation so that we can submit a build job
to the SLA system?

Is the software loaded?

Is the computer on the network?
FAX this completed page to (803) 324-4311
Completed by:
Customer Representative Date
Assigned 3D Systems Customer Support Engineer Forwarded Date
9
PART FINISHING AREA
SLA SYSTEM AREA