11
3D Systems, Inc.
INSPECT EXTERIOR OF PRINTER
Visually inspect the exterior of the printer for any damage incurred during shipping. Notify 3D Systems
Service immediately if anything is evident at this point. DO NOT proceed with the installation until you
have discussed the damage with Service.
INSPECT SHOCKWATCH
®
INDICATOR
Check the ShockWatch
®
indicators (towards top of crate and at bottom of crate).
If indicator(s) are red:
1. Do not refuse shipment
2.
Make notation on delivery receipt and inspect the container for signs of damage
3. If damage is discovered, leave item in original container and packaging, and request immediate inspection from carrier
within 15 days from delivery date.
If indicator is not red, machine is cleared to uncrate by a 3D Systems Field Service Engineer or an authorized reseller.
SHIPMENT ARRIVAL
The ProX 950 facility will arrive in a variety of crates and/or pallets - the largest crate being the ProX 950.
Once your shipment arrives, first inspect the crates for any physical damage. Then, after inspection, receive the crates.
The following chart lists both crated and uncrated dimensions and weights for every possible crate that you may have ordered.
Verify your order and compare to the listed items below. Crates or pallet dimensions and weights may vary.
Crated Specifications
Uncrated Specifications
Width
Depth
Height
Weight
Width
Depth
Height
Weight
Weight w/
resin
Description
cm
(in)
cm
(in)
cm
(in)
kg
(lb)
cm
(in)
cm
(in)
cm
(in)
kg
(lb)
kg
(lb)
ProX 950
246
(97)
188
(74)
254
(100)
2087
(4600)
221
(87)
160
(63)
226
(89)
1814
(4000)
n/a
Laser Unit (laser, power supply) 94
(37)
64
(25)
89
(35)
91
(200)
19
(7.5)
53
(20.9)
17
(6.7)
22.7
(50)
n/a
Manual Offload Cart
127
(50)
174
(68.5)
157.5
(62)
160
(350)
76
(29.8)
140
(55.1)
118
(46.3)
90
(200)
n/a
ProCure™ 1500 UV Chamber
154
(60.8)
138
(54.5)
172.7
(68)
520
(1120)
148
(58.3)
120
(47.2)
178
(70.1)
30
(950)
n/a
RDM ProX 950
183
(72)
183
(72)
112
(44)
454
(1000)
160
(63)
142
(56)
79
(31)
340
(750)
1353
(2977)
Figure 14: Weight and Dimensions - System Components
TRANSPORTING THE PROX 950
When the 3D Systems Field Engineer arrives, and the crate is opened, use a forklift to lift the system. Refer to the following
diagrams illustrating the forklift points.
Figure 13b: Fork lift points - Recommended fork length is
2m (6.5 ft)
Figure 13c: Center Shipping Bar
