3D Systems PostCure 1050, User Manual, Page: 39 / 68

2. When the test is finished, the button will turn yellow. If you
will be replacing the light bar, tap LOG to create a record of
the replacement; you will see a confirmation screen (below) to
officially log the record.
6.2 PostCure 1050 Cure a Printed Part
WEAR 100% NITRILE GLOVES WHENEVER HANDLING UNCURED (GREEN) PARTS.
1. Place green parts on the base glass shelf and on the
optional middle glass shelf if installed. Spread out parts
from each other to ensure good air flow around parts
and to minimize shadowing from one part to another
part.Place green parts on the base glass shelf and on the
optional middle glass shelf if installed. Spread out parts
from each other to ensure good air flow around parts and
to minimize shadowing from one part to another part.
3D Systems, Inc. 36 p/n 40-D177, Rev. A