Manual_DTC133UHL_EN
Rev. 1.0 / 17.11.2022
6 / 18
2 The device
2.1 Device description & variants
The device may be available in different variants with different characteristics. The
description and technical data applicable to the respective variant are listed in the
corresponding datasheet.
Unless otherwise indicated, the information given in these operating instruction applies to
all variants.
2.2 Symbols
The type plate of the device contains various symbols whose meaning is described here:
Before using the device for the first time, read this operation instruction
completely and carefully, as it contains among other things important safety
instructions.
The device may only be operated in closed rooms. For more information,
please refer to the “Safety” section starting on page 7 of this operation
instruction.
2.3 Scope of delivery
•
one autostereoscopic 3D display
•
this operation instruction
•
one datasheet
Optional available accessories are listed in the datasheet.
2.4 Technical function
The autostereoscopic (glasses-free) 3D display is controlled via the permanently attached
signal cable (DisplayPort) with a specially processed 3D signal. Additional hardware and
software are required for this.
The display uses an integrated optical filter to optically separate the stereoscopic image
content from each other and creates several viewing areas in front of the display in which
the image content can be perceived spatially without having to wear special glasses.
The head tracking camera integrated in the display housing can detect the user's viewing
position and continuously track the 3D image on the display, so that the user can move
relatively freely in front of the display. Special headtracking software is required for this.
