3D Corporation ProJet 5000, Manual

Page: 12 / 94

To find out facility disposal requirements, contact a local waste disposal provider. (Local environmental regulatory agency should have a list of
qualified providers.) You will need to give disposal service provider a copy of the part material MSDS, and possibly other forms included in the
Appendix of your
, such as Waste Profile Worksheet and SNUR (Significant New Use Regulation - U.S. only). VisiJet® Material Handling Guide
A report will be provided, indicating disposal requirements, as well as a quotation for regularly scheduled pickups. If assistance is needed locating
a waste disposal provider, or completing a waste disposal form, contact 3D Systems;
Hotline. Technical Support
3D Systems assumes no liability or responsibility for proper disposal of uncured part material. Proper disposal of uncured material is the sole
responsibility of the user.
4.2 Health Hazards
Irritant
Caution: Uncured VisiJet® part material is
a sensitizer. Skin or eye irritation could
occur when exposed to the chemical
composition of the material.
Any chemical may exert harmful effects if contacts or enters the body. VisiJet® part material is
a sensitizer and irritant.
Skin Sensitization: Uncured VisiJet® part
material is a sensitizer. Skin or eye irritation
could occur when exposed to the chemical
composition of the material. Uncured material is a sensitizer, and can cause allergic reactions if contacts skin without
protective gloves. Refer to
for more information. To avoid personal protection equipment
sensitization, do not allow uncured material to contact skin. Consult the MSDS for specific
information about the sensitization potential.
Ingestion: Uncured VisiJet® part material is
toxic if ingested.
Uncured material is toxic if ingested. Uncured material must not be present where food and
drink are *stored, prepared, or consumed and not ingested. After handling materials, wash
hands with soap and water before consuming or preparing food.
Inhalation: Under normal operation, inhalation is not an expected route of entry.
Contact With Uncured Material
Employees should be alerted to clean and rinse off any contacted surface promptly in order to prevent further contamination. Ensure a convenient
washroom location is provided with access to soap, water, and disposable paper towels.
Handling Finished Parts
Finished (cured) parts can be handled or disposed of the same as standard household plastic products. VisiJet® parts are not recyclable. VisiJet®
materials are not intended for, and cannot be used for medical implant, or food or drink handling applications.