3Com VCX V7000, Maintenance Manual

Page: 56 / 344

56 C
HAPTER
3: M
ANAGING
VCX S
ERVERS
Using EMS
To restart the Call Processor service from EMS:
1 From the Explorer tab, right-click the 3Com Call Processor service.
2 From the pop-up menu, select Maintenance , then select Hard Restart
to shutdown and restart the Call Processor service.
Managing the
Accounting Service
and the
Authentication and
Directory Service This section describes maintenance tasks for the following VCX services
(sometimes referred to as back-end servers):
■
Accounting service
■
Authentication and Directory service
The location of each service depends on your VCX configuration.
■
The Accounting service always runs on the server hosting the IP
Telephony server.
■
The Authentication and Directory service can run on either the IP
Telephony server or, in some multi-site configurations, on the
Authentication and Directory server.
To determine where (the IP address) a service is running, enter the
following command (logged in as
root ) on the server hosting the primary
call processor:
vcx-config-services --show
This command returns a multi-page display that shows your VCX system
configuration, including lines similar to the following:
---------Displaying Accounting Service ---------
Local IP Address : 10.230.63.6
For information on configuring Accounting Service groups, see
Chapter 2 .
For information on Authentication and Directory service database
maintenance, see
Chapter 5 .