3Com Switch 4800G PWR 24-Port, Configuration Manual, Page: 596 / 730

1-13
To do… Use the command… Remarks
Enable system information
output to the trap buffer
info-center trapbuffer
[ channel { channel - number |
channel - name } | size
buffersize ]*
Optional
By default, the switch uses
information channel 3 to output
trap information to the trap
buffer, which can holds up to
256 items by default.
Configure the output rules of
system information
info-center source
{ modu - name | default }
channel { channel - number |
channel - name } [ { log | trap |
debug } { level severity | state
state } ]*
Optional
Refer to Table 1-4 for the
default output rules of system
information.
Set the format of time stamp in
the output information
info-center timestamp { log |
trap | debugging } { boot |
date | none }
Optional
By default, the time stamp
format of the output trap
information is
date .
Setting to Output System Information to the Log Buffer
Follow these steps to set to output system information to the log buffer:
To do… Use the command… Remarks
Enter system view system-view —
Enable the information center
info-center enable
Optional
Enabled by default.
Enable information output to
the log buffer
info-center logbuffer
[ channel { channel - number |
channel - name } | size
buffersize ]*
Optional
By default, the switch uses
information channel 4 to output
log information to the log buffer,
which can holds up to 512
items by default.
Configure the output rules of
system information
info-center source
{ modu - name | default }
channel { channel - number |
channel - name } [ { log | trap |
debug } { level severity | state
state } ]*
Optional
Refer to Table 1-4 for the
default output rules of system
information.
Set the format of time stamp in
the output information
info-center timestamp { log |
trap | debugging } { boot |
date | none }
Optional
By default, the time stamp
format of the output log
information is
date .
Setting to Output System Information to the SNMP NMS
Follow these steps to set to output system information to the SNMP NMS:
To do… Use the command… Remarks
Enter system view system-view —