Administering IP Interfaces
65
Make sure that you define a VLAN, as described in your Switch
management guide, before you define an associated IP VLAN interface.
To define an IP interface:
1
Enter the following at the top-level menu:
ip interface define
The following prompt is displayed:
Enter IP address:
2
Enter the IP address of the interface.
Enter subnet mask [255.255.0.0]:
3
Enter the subnet mask of the interface.
Enter VLAN interface index [2]:
4
Enter the VLAN index that is associated with the 802.1Q VLAN ID for this
VLAN.
Modifying an IP
Interface
You can change the configuration of an interface you have already
defined.
To modify an IP interface:
1
Enter the following at the top-level menu:
ip interface modify
The following prompts are displayed:
Select IP interface {1-4}:
Enter IP address [12.0.0.2]:
Enter subnet mask [255.0.0.0]:
Enter VLAN interface index {3|?} [3]:
2
Modify the existing interface parameters by entering a new value at the
required prompt(s).
Removing an
Interface
You can remove an interface if you are no longer using it to route on the
ports associated with the interface.
To remove an IP interface:
1
Enter the following at the top-level menu:
ip interface remove
The following prompt is displayed:
Summary of Contents for SuperStack II 3300
