3Com PS Hub 40, User Manual

Page: 85 / 188

DUA1640-5AAA02
Commands 6-9
Viewing the
Configuration
You can use the display command to show current configuration
information for your hub or stack.
Displaying the Hub Configuration
At the top-level menu, enter:
system display
The CLI displays information similar to this example:
3Com PS Hub 50 (3C16450)
Unit Name: Marketing
Location: Top floor
Contact: James
Time since reset: 2 days, 3 hours, 10 minutes
Operational Version: 1.00 Boot Version: 1.00
Hardware Version: 1.00
Serial Number: 2103332
This information is in the hub’s MIB (Management Information Base)
and is read-only. You can change the Unit name, Location and Contact
using the web interface.
If a problem occurs and you need advice from your support
representative, you may be asked for some of the information shown
on this screen.
Displaying the IP Configuration
At the top-level menu, enter:
ip interface display
The CLI displays the IP address, subnet mask, default router address,
SLIP address and SLIP subnet mask for the hub.