3Com OfficeConnect WX1200, Reference Manual

Page: 354 / 520

354 C
HAPTER
10: M
ANAGING
WX S
YSTEM
I
MAGES AND
C
ONFIGURATIONS
Deploying Switch
Configuration
Changes
You can deploy changes immediately or schedule them to be deployed
later.
When you deploy changes to a WX, all of the changes are sent as a single
transaction. If any parameter is unsuccessfully changed, the entire
transaction is rolled back. If the transaction is successful, the
configuration changes are immediately and dynamically put into effect.
(A reboot is not required.)
The following procedures provide steps for deploying configuration
changes from the Devices tab. You also can immediately deploy changes
from the Configuration tab, by clicking
Deploy .
To immediately deploy local changes
1 Select the Devices tool bar option.
2 At the bottom of the Task List panel, select Change Management.
3 Select one or more WX switches.
To select multiple switches, press Shift (for contiguous switches) or
Control (for noncontiguous switches) while clicking.
4 In the Local Changes group in the Task List panel, click Deploy . The
Deploy Configurations dialog box appears.
The dialog lists the switches that have configuration changes.
5 Select the switches to which you want to deploy the changes.
To select more than one WX, click Shift while clicking to select
contiguous items, or click Ctrl while clicking to select noncontiguous
items.
6 Click Deploy .
The deployment status for each affected WX is shown in the History
window at the bottom left of the dialog box.
3WXM performs verification of the changes. If errors occur, they are listed
in the Selected Errors at the bottom right of the dialog box. If there are
errors, fix them and verify the changes before trying to deploy again. (You
can use the Verification tab to fix the errors. See “” on page 365.)
If the deploy is successful, 3WXM also instructs the WX switch to save the
changes in its configuration file.
7 Click Close .