86
C
HAPTER
5: C
ONFIGURING
THE
P
LATFORM
Resetting All
Parameters
You can reset all parameters for the CoreBuilder 9000 ATM Enterprise
Switch.
Reset All
Reset all configuration parameters for the CoreBuilder 9000 ATM
Enterprise Switch to their factory default settings.
Some parameters are reset only after the next reboot. These parameters
include ATM addresses, PVC, IP parameters, and NMS parameters.
Command Actions
Command Result
Example
Enter:
1 2
1
The following message is displayed:
Reset of all saved configuration was done.
All configuration parameters are reset to their factory values.
Enter the menu sequence:
(1) SYS: Platform Configuration
(2) FLS: FLASH setup
(1) RES: Reset Config to Defaults
Direct access sequence:
1 2 1
System action taken:
All configuration parameters are reset to their factory
default values.
System message display:
Reset of all saved configuration was
done.
Summary of Contents for CoreBuilder 9000
