CHAPTER 7: Configuring the Broadband Connection
64
Configuring the Connection Type
Configuring the Connection Type
The connection type identifies the method by which the gateway connects to the ISP.
1.
Open a Web browser and enter
http://home, http://gateway.2Wire.net, or
http://192.168.1.254
to access the gateway user interface.
2.
Click
on the
Home
page; the
Summary Status
page opens.
3.
Click
Link Configuration
; the
Link Configuration
page opens.
4.
Scroll down to the
Connection Type
pane.
5.
Select the connection type from its corresponding drop-down list.
•
If you selected the Direct IP, continue with the next step.
•
If you selected the PPPoE or PPPoA, continue with the
section to set up your username and password.
6.
Select the
Enable
check box for
Auto Wan Address Mode
field to automatically select
the WAN interfaces (ADSL/ADSL2/ADSL2+).
Summary of Contents for HomePortal 4011G
Page 1: ...Gateway Installation and User Guide 4011G Version 9 1 1 Rev 001 ...
Page 6: ...CHAPTER 1 Presenting the 4011G Gateway 2 This page is intentionally left blank ...
Page 70: ...CHAPTER 7 Configuring the Broadband Connection 66 Configuring PPP Authentication and Settings ...
Page 72: ...CHAPTER 7 Configuring the Broadband Connection 68 Modifying Broadband IP Addresses ...
