41
2VV.
Creating innovative solutions for you and your business since 1995.
ATTENTION!
In case of power failure and subsequent recovery of the
mains power supply, the unit returns to the state before
such failure.
The unit always remembers the operating status and all
setups. If you fail to find or remove the cause of the fault,
or if the repair requires intervention in the device, contact
the authorised service
Electric heating overheat:
If the electric heating overheats, the safety thermostat is
disconnected. Upon removing the cause of such overhe
-
at, it is necessary to reset manually the safety thermostat
located directly on the electric heater.
Location of the safety thermostat is indicated with
RESET mark in each unit
9. FAULTS REMOVAL
Replacing the wheel motor
In case of damage, it is possible to buy a spare part for
replacement.
Replacement procedure:
1. Disconnect the connector on the cables.
2. Take off the belt from the motor pulley.
2. Unscrew the screws holding the motor.
3. Remove the motor.
4. Place the new motor and screw it on.
5. Connect the cables and thread the belt back on the
pulley.
