54
2N TELEKOMUNIKACE a.s., www.2n.cz
2N NetSpeaker Connections
®
Set the connection parameters for
in the passive mode (refer to
2N NetSpeakers
®
the
scanner below).
the parameters to establish connection to
2N NetSpeaker
®
Save
2N NetSpeaker.
®
Parameters:
Connection timeout
– define the time interval between the connection making
attempts.
IP address
– set the
IP address.
2N NetSpeaker
®
IP port
– set the
port; 6998 is the default value.
2N NetSpeaker
®
Automatic firmware upgrade
– disable the
firmware
2N NetSpeaker
®
upgrade.
Figure: Connection Parameters
2N NetSpeaker Scanner
®
Use the
scanner to search for the
units and their
2N NetSpeaker
®
2N NetSpeaker
®
settings in the network. All speakers available in the network are displayed to the left.
Having selected a speaker, you can change its parameters in the right–hand part to
make it connect to the
automatically (active mode), or using
2N
®
NetSpeaker Server
the
parameters.
NetSpeaker connections
Caution:
If there is a yellow-highlighted NetSpeaker in the scanner, please check
the domain (both on the server and end device sides), or
check the license for excessive count of devices for trial use.
Summary of Contents for NetMic
