2N ISDN BRI GSM, User Manual

Page: 86 / 109

2N - ISDN BRI GSM Enterprise Gateway
Fig. 58 – LCR table Data Entering
By completing the LCR data adding table you set one call routing
rule.
•
Network ID – select a group from the Network list in the
pull-down menu to which the routing rule should apply.
The group settings are discussed in Subs. 8.10.
•
Groups – this list is used for selecting of GSM outgoing
group (refer to Subs. 8.8). All outgoing calls are routed to
the respective GSM module according to the selected
group. The routing priority is from top to bottom.
Therefore, if the top parameter (GSM group 1) cannot be
used, the call is routed according to the parameter under
the first one (GSM group 2). Setting of routing according
to
Any group/module is required if the parameter ISDN
parameters - Channel selection is set up to Cyclic or
Smart . Use group BRI2 to set up routing of calls to BRI2
port according to prefixes in Network list
•
Time limitation of use– sets the time limit for the routing
rule defined in this menu. The time validity From – To
may include weekends too.
•
Max. length of call – limits the call duration to the network
selected in Network number through the GSM group
selected in Groups . To disable the call duration limitation
set the value at 0 .
76