2N Access Unit, Configuration Manual

Page: 104 / 134

2N Access Unit Configuration Manual
104 / 134
5.5.1 Network
As the 2N Access Unit is connected to the LAN, make sure that its IP address has been set
correctly or obtained from the LAN DHCP server. Configure the IP address and DHCP in the
Network subsection.
If you use the RADIUS server and 802.1x-based verification of connected equipment, you can
make the intercom use the EAP-MD5 or EAP-TLS authentication. Set this function on the 802.1x
tab.
The Trace tab helps you launch capture of incoming and outgoing packets on the 2N Access
Unit network interface. The file with captured packets can be downloaded for Wireshark
processing, e.g. ( www.wireshark.org).
List of Parameters
•
Tip
To know the current IP address of your 2N Access Unit , use the 2N IP Network
Scanner , which can be freely downloaded from www.2n.cz , or apply the steps
described in the Installation Manual of the respective 2N Access Unit : the 2N Access
Unit communicates its IP address to you via a voice function.
