2N Telekomunikace NetSpeaker, User Manual

Page: 30 / 39

Basic Functions 4.1
30
4.1 Basic Functions
2N
®
NetSpeaker Button Control
2N
®
NetSpeaker is equipped with two buttons on the front panel.
Use these buttons to adjust volume or change the channel number. Select the button
control mode in the configuration menu for each 2N
®
NetSpeaker unit in the 2N
®
NetSpeaker Control Panel application; refer to the 2N
®
NetSpeaker Software User
Manual.
2N
®
NetSpeaker Remote Control
2N
®
NetSpeaker is equipped with an infrared remote control receiver.
Use the remote controller (Part No. 914101E) for volume adjustment and channel
selection.
Tip

The remote controller is not part of the standard delivery. Order it under
Part No. 914101E.
Be sure to set the remote controller into the 2N
®
NetSpeaker compatible mode before
the first use of after every battery replacement. Follow the steps below:
Remote Controller Setting
1. Press and hold the MAGIC button until the controller flashes twice.
2. Press sequentially the following buttons: once the left button, once the right
button, twice the middle button and once the left button.