Copyright © 2022 Nortek Security & Control LLC
33
Sensor Reports
1 .
Highlight
Sensor Reports
.
2 .
Choose
Enabled
or
Disabled
.
3 .
Tap
to move to the next option.
P
anel
P
rogramming
– K
eyfoBs
Program up to 32 keyfobs per system. To begin, navigate to the
Installer Toolbox
, then tap Panel Programming > Keyfobs.
Select a Keyfob
1 .
Swipe up to move through the list of keyfobs.
2 .
Tap to select one of the available keyfobs.
3 .
Tap
Edit Keyfob
.
1 .
Highlight
Fob Active
.
2 .
Under
Fob Used
, choose
Enabled
or
Disabled
.
3 .
Tap
to move to the next option.
Select Equipment Code
1 .
Highlight
Equipment Code
.
2 .
Tap
≡
to expand the list.
3 .
Tap to select the desired equipment code from the list.
4 .
Tap
to move to the next option.
Serial Number
1 .
Highlight
Serial Number
.
2 .
Tap
Learn
to enter Learning Mode.
3 .
The 7-digit TX-ID listed on the product is detected.
4 .
Press any button on the keyfob for three 3 – 5 seconds. The
Sensor
Received
message appears if successful.
TIP:
Along with Learning Mode, you also have the option to
manually enter the 7-digit TX ID using the keypad.
5 .
Verify the on-screen serial number matches the keyfob’s 7-digit TX ID,
then tap
Accept
.
6 .
Tap
to move to the next option.
Edit Voice Descriptor
Create a voice descriptor for the keyfob using the words in the
system’s vocabulary.
1 .
Highlight
Voice Descriptor
.
2 .
Tap
Edit Voice Descriptor
to view the keypad.
3 .
Enter the first few letters of the desired word.
4 .
Tap the matching vocabulary word above the touchscreen keypad to
select it.
5 .
Repeat the steps to enter phrases, then tap
Done
.
6 .
Review the voice descriptor.
7 .
Tap
to move to the next option.
