10ZiG Technology Limited ZiGnature Pad 1410, User Manual

Page: 13 / 42

- 13 -
4. Plug the cable attached to the AC adapter in to the DC In port on the rear (shown in
Figure 2Figure 2: ). Plug the other end of the power adaptor in to an AC outlet.
The hardware is ready. Turn on the Zignature Pad by pressing the button on the right (shown
in Figure 3). If you have a USB connection, you should now see a blue flashing light on the
Zignature Pad. After a few seconds, you should see the default screen (the 10ZiG logo). If
necessary, see the
Troubleshooting section.
Warning Do not attempt to open the digital pen. This may cause the pen to
malfunction and is not covered by the warranty.
Safety Precautions

Use the power cord supplied with your Zignature Pad.

Plug the power cord directly into a properly grounded electrical outlet. If you do not
know whether an outlet is grounded, ask an electrician to check the outlet.

Do not use an extension cord.

Do not place the Zignature Pad where people may step on the power line or USB
cable.

Do not place objects on the Zignature Pad or the power adaptor.
Looking after your Zignature Pad

Do not place the Zignature Pad near a heat source or in direct sunlight.

Do place the Zignature Pad on a level, solid surface with adequate strength for the
weight of the device.

Do not place any liquids on or near the Zignature Pad . For cleaning instructions, see
Cleaning the Pen and Zignature Pad Frame .

There are no user serviceable parts inside the Zignature Pad. Do not disassemble the
device.
3. Opening the Document Monitor
The Document Monitor is software located on your computer that provides you with an
interface to the documents. To open the Document Monitor, right click the
VPort Agent icon
in the Windows notification area and select Run Document Monitor .
At the moment, no document is displayed. All you can see is a toolbar at the top of the
screen. We will explore the options available to you later, in
Using the Document Monitor .
4. Connecting to Your ERP System
Usually the company’s ERP system takes control of the created documents. If there is no ERP
interface and VPortal is installed, VPortal handles the documents and stores them on the
VPortal server.