10ZiG Technology Limited ZiGnature Pad 1410, User Manual

Page: 12 / 42

- 12 -
2. In the VPortal Server connection tab, type the relevant data in the VPortal IP
address .
3. If you want an alternative IP address, add it.
4. Click Apply .
2. Installing the Hardware
Warning Do not connect the USB adapter to the computer until the software
prompts you to do so.
Figure 5 10ZiG Zignature Pad: USB option with wireless pen – for illustration purposes only
1. Place the Zignature Pad on a stable surface where there is adequate room to
operate it.
2. Connections:
o
If you have a USB cable:

Connect USB-B (shown in Figure 1) to the rear of the Zignature Pad.

Connect USB-A to a USB port on the host computer (it is
recommended to use a USB port that is close to the motherboard).
o
If you have a network cable:

Connect one end to Port 1 on the rear of the Zignature Pad (shown
inFigure 2: , close to the USB port) and the other end to the network
outlet.

(Optional) The Zignature Pad acts as a network switch. Connect one
end to Port 2 on the Zignature Pad and the other end to your host
computer.
3. Wireless pen:
o
If necessary, remove the battery compartment cover and install one AAA
battery with the positive “+” facing up. Replace the battery compartment
cover.
240V
60Hz