To Pack a Preset:
After you spend time carefully creating a preset, you don’t want to worry about it getting
broken if you make changes to that WAV file or re-organize your sample library. You may
also want to gather up all of the files used in a preset so you can move it to another
microSD card or archive it on your computer. The Pack feature was created to address
these needs.
1.
Load the preset you want to pack.
2.
Push
PSET
and then touch
File->Pack
. Blackbox will find all of the WAV files that
are assigned to pads and copy them into the folder for this preset. Multi-sample
banks will be copied to a sub-folder.
Note:
►
If you continue to add WAV files to your preset after you pack it, the
preset will still point to these WAV files in their source folders. Pack the
preset again to copy these files over.
►
If the Pack option is disabled, then the preset is fully packed already.
Note:
►
If you delete, move or rename a WAV file, it will no longer be available
for use by presets that were previously using it. The name of the
original WAV file will still appear in the preset, but the Waveform screen
will be blank until you load a new WAV file into the pad.
►
To remove a WAV file from a pad without deleting the file, go to the
Waveform screen and touch the Pad Mode icon to the left of the file
name, and then touch
New Recording
. You can press
PADS
to go back
to the Pads screen without loading a file and the pad will be empty.
Page 57 of 106
Copyright 1010music LLC 2021
Blackbox User Manual 1.7
