Note:
►
If you use an existing file name when you use
Save As
, the old file will
be overwritten with the current WAV file and parameters.
Note:
►
These parameters are saved in a format that is commonly used by
other music products. This means you can set these values in the other
product and then use them in blackbox, and the reverse.
►
When blackbox first loads a WAV file that has parameters stored in it, it
will load the values of the parameters that are in the WAV, and use
default values for the other parameters. If you change a value of one of
these parameters for the pad, those changes only apply to this pad,
and are not automatically saved back to the WAV file. This allows you to
override parameters for specific pads.
►
When loading a WAV file, blackbox makes an assumption about the
pad mode based on the parameters that are available in the WAV file. If
there are slices in the WAV, then it sets the pad mode to slicer. If there
are loop points in the WAV, then it sets the pad mode to sample.
To save the values you have configured for a pad back to the WAV
file:
1.
Open the WAV screen for the pad.
2.
Touch the name of the WAV file at the top of the screen to
display the WAV selection screen.
3.
Touch File and then Save or Save As. If you select Save,
blackbox will save the configured parameters into the same
WAV file you have loaded. If you choose Save As, you will
see the WAV file naming screen. Type in a new name to
save the changes to a different WAV file, and then touch
Enter to save. Blackbox will now load the newly modified
WAV file into the pad.
To revert back to the parameter and slice values stored in the WAV
file, simply reload the file into the pad.
WAV File Actions
Menu
Copyright 1010music LLC 2021
Page 52 of 106
Blackbox User Manual 1.7
