NOTE:
► The Clock input must use 4 pulses per quarter (PPQs), or a pulse per 16th note.
► If MIDI and CLOCK inputs are both used, Bitbox micro will select the highest
priority clock based on the following order of priority: 1.) CLOCK Input; 2.) MIDI
Input; 3.) Internal Clock.
► See
above for more information about synchronizing clips.
Send the Bitbox micro Clock Signal to External Devices
Bitbox micro sends out a MIDI clock signal through the TRS MIDI output. Be sure to
check TRS Mini-jack compatibility. See
Pin Mapping for Mini TRS Jack to MIDI 5 Pin
below for more information about compatibility. The MIDI out uses TRS
MIDI Type B.
Bitbox micro sends an analog pulse clock through the Clock Out port. It sends a clock
pulse signal with 4 pulses per quarter (PPQs), or a pulse per 16th note.
Reset the Clock
You can use the following methods to reset the clock counter back to 1:1:
■ Stop the Clock input for a few seconds and then restart it.
■ Receive MIDI play and MIDI clock signal.
■ Power down the module.
Copyright 1010music LLC 2020
Page 80 of 88
Bitbox Micro User Manual 1.0.7
