P. 75
nanobox | tangerine User Manual
Dec 11, 2023
Edit Loop Points in the Waveform Screen
When Loop Mode is Forward or Bidirect, the Waveform screen presents loop start and end
point markers.
Loop Start and Loop End Points in the Waveform Screen
Note:
When a pad’s Loop Mode is Off, the Waveform screen hides the loop point
controls.
1.
Select the Loop Start parameter by turning the top knob until Loop Start appears at
the bottom of the screen.
2.
Use traditional swipe, pinch, and spread gestures on the touch screen to zoom in on
the part of the waveform where you want to move the Loop Start.
3.
Move the Loop Start point with the bottom knob. Notice that the Loop End point
does not shift when you move the Loop Start point.
4.
Select the Loop End parameter by turning the top knob until Loop End appears at
the bottom of the screen.
5.
Move the Loop End point with the bottom knob.
