background image

LCD PROJECTOR LENS

MODEL NO. LNS-S02Z

LENS REPLACEMENT 
AND INSTALLATION PROCEDURES

NOTES ON REPLACEMENT AND INSTALLATION

The procedures and the needed pars for lens installation depend on the type of
cabinet.  Before installing or replacing the lens, make sure the type of cabinet and be
sure to refer to the Installation Manual corresponding with your projector.
When installing or replacing the lens, make sure the Lens Model No. matches with
your projector.  Refer to the catalog, or contact your sales dealer for the proper Lens
Model No.

TYPE OF THE CABINET AND REFERENCE INSTALLATION MANUAL

Refer to the Installation Manual corresponding to your projector.  
(See the chart below.)

Type of the Cabinet

Reference Installation Manual

Refer to this manual.

Refer to the Installation Manual

supplied with the Projector.

Other than the above cabinet

design.

Summary of Contents for LNS-S02Z

Page 1: ...Manual corresponding with your projector When installing or replacing the lens make sure the Lens Model No matches with your projector Refer to the catalog or contact your sales dealer for the proper Lens Model No TYPE OF THE CABINET AND REFERENCE INSTALLATION MANUAL Refer to the Installation Manual corresponding to your projector See the chart below Type of the Cabinet Reference Installation Manu...

Page 2: ...ure to replace the lens cover before installation When installing or replacing the lens be careful not to stain scratch or damage the lens After installing or replacing the lens be sure to check the following for safety 1 Check the lens is securely fixed by 4 screws 2 Check no wiring is tangled on the gear of lens motor or the other mechanical parts 3 Check no part is missing or no mounting part i...

Page 3: ...aced Two screws are not used 4 REMOVE THE COVER PLATE OF THE LENS COVER See figure 2 INSTALL THE LENS See figure 3 3 LENS MOUNTING BRACKET ATTACHED DRIVER Fig 3 LENS MOTOR Perform the steps to for lens replacement and installation 5 1 1 Remove protective caps front and back on the lens 2 Mount the lens on mounting bracket of the main cabinet with 4 screws Use the screws included with the lens Use ...

Page 4: ...ews 5 UPPER LENS COVER LOWER LENS COVER A B Fig 5 Fig 6 When in install the both upper and lower lens cov ers install the light block sheet so that it should be placed in the guide slot of the lens cover If the installation of the light block sheet is incorrect there will be the space between lens and the lens cover so that it will be the cause of leakage of light or the dust entering at the main ...

Reviews: