★
This is to explain the procedure for combining a sub screen image with the background image.
(Procedure for selecting the PinP signal)
①
Press PinP button – (Fig.1-A) to set the crosspoint buttons to PinP material selection mode (PinP button blinks).
②
Using the B bus buttons, select the PinP signal. – (Fig.1-B)
③
Press PinP button to release the PinP material selection mode(PinP button goes off).
④
Press PinP ON button – (Fig.1-E) to combine the PinP image.
(PinP settings)
Changing the shape, position and size of the PinP image to be combined is enabled as well as adding the border effect to
it.
⑤
Hold down the OSD ON button – (Fig.1-C) for 2 seconds to open the menu. (To close it, hold down the button again
for 2 seconds.)
⑥
Use the OSD/TIME dial – (Fig.1-D) to set or adjust the settings for the menu items in [3] PinP Menu. – (Fig.2 & Fig.3)
＝
＋
Combining PinP (Picture in Picture)
(Figure 1: AW-HS50 Control Panel)
（
A
）
（
B
）
（
C
）
（
D
）
（
E
）
Background
PinP Signal
Output Image
(Figure 2: AW-HS50 Menu Display Screen)
