BatteryShip.com
F1798 HP Jornada 520, 525 Series Battery Installation Instructions
PLEASE NOTE:
Patience and care, along with moderate technical and hand tool ability, are required for the successful
replacement of a PDA battery.
Excessive force may result in damage to your PDA.
The instructions below come with
no warranty or guarantee. By utilizing these instructions, you agree to hold Batteryship.com blameless and unaccountable
for any and all damages, problems, or personal injuries that may or may not arise by your use of these instructions.
Replacing your Jornada battery may void any warranty you have on your Jornada.
Please read all instructions and
back up your data BEFORE replacing the battery.
Included Phillips Screwdriver Included Plastic Flathead Screwdriver
Step 1.
Remove the four screws on the back of the PDA using the included
Phillips screwdriver. Set the screws aside for reassembly.
Step 2.
Once the screws have been removed, GENTLY
pry open the Jornada case (starting at the top, as
shown) using the included plastic screwdriver. Pry
around the device until the back cover comes open
completely.
Step 3.
Remove your old battery from its seat, using the enclosed plastic
flathead screwdriver to assist (as shown) if necessary.
Leave the
connector plugged in for this step.
The battery may be glued in,
so pry under it GENTLY until it comes loose. Take care not to break
the old battery while removing it.
Step 4.
Disconnect the old battery at the connector by
CAREFULLY pulling outward on the connector
with your thumb and forefinger or tweezers. Be
very sure that you are pulling outward on only the
part of the connector that comes out, as shown,
NOT on the whole connector.
(Steps 5 & 6 continued on back)
