INSTALLATION INSTRUCTIONS
Put Bar Code Here
62-0349-01
NPB-ZWAVE Option Card
This document covers the mounting of a NPB-ZWAVE option
card in a Tridium
®
JACE
®
controller, including models WEB/
CP-600, WEB/CP/700, WEB/CP/602-XPR, or WEB/CP
controllers.
NOTE: The WEB/CP Controller requires NiagaraAX-3.5 or
later to support operation of the NPB-ZWAVE.
Not covered in this document are NiagaraAX Z-Wave driver
(software) topics about using this option card. For all other
related mounting and wiring details, refer to the appropriate
mounting and wiring document. See “Related
Documentation”.
INCLUDED IN THIS PACKAGE
Included in this package you should find the following items:
• NPB-ZWAVE option card, with pre-attached endplate.
• an RP-SMA coax-mounted stub antenna.
• This document
NPB-ZWAVE
Option Card Installation
Instructions
, Form Number 69-0349.
Fig. 1. NPB-ZWAVE Option
MATERIAL AND TOOLS
REQUIRED
The following supplies and tools are required:
• #2 phillips screwdriver: used to install the NPB-ZWAVE
option card.
• If installing in a WEB/CP-XPR (WEB/CP-202/602-XPR), an
antenna cable kit. See “Antenna Extension Option”. Also, a
#1 phillips screwdriver.
Table 1. NPB-ZWAVE option description.
Description
Models /Notes
Z-Wave wireless option
card for serial gateway
support between the
hosted WEBStation-AX
or Comfort Point
Workbench and an RF
wireless Z-Wave domain.
This option card allows
NiagaraAX integration of
wireless Z-Wave
devices.
An RP-SMA coax stub
antenna is included.
Four status LEDs are on
the option card’s top
surface.
NPB-ZWAVE
- For domestic
U.S. usage.
908.42 MHz frequency
An optional antenna extension
kit allows the included antenna
to be located up to 6.56 feet
(2m) away from the option
card.
This kit is required if installing
in a WEB/CP-202-602
controller model. See “Antenna
Extension Option”.
The NPB-ZWAVE option card
adds one COM port on the
JACE controller. See “COM
Port Usage”.
TX
RX
SERIAL
LED1
LED2
M32453
STATUS LEDS
STATUS LEDS
ANTENNA
CONNECTOR
RP-SMA COAX
SUPPLIED
STUB
ANTENNA
