Honeywell Life Safety AS, Po. Box 3514, N-3007 Drammen, Norway
http://www.hls-nordic.com
Wireless
Module
part no. 290091.2
Installation / installasjon / installation:
The device comes with 4 label stickers that contain a Unique identification code (UID) that is
hexadecimal formatted in 4 bytes. An example UID is 45 90 DB FA. It is advised to stick one sticker
on the module and one sticker on the luminary that the module will be fitted in. The two remaining
stickers may be placed on a printed floor plan, text lists etc.
-
Disconnect mains. Refer to the luminaire installation manual for disassembly.
-
Disconnect the battery.
Carefully insert wireless module as shown in picture above.
-
Reconnect the battery and observe the module’s LEDs for proper operation. Assemble the luminaire.
-
Reconnect mains. You are now ready to setup the module for network communication. For the network
setup refer to the wireless network commissioning manual.
Function
This device has three indication LEDs.
Top LED (green): RF connection status
Steady on:
The device has established direct connection to a Gateway Device, and at least
one more Gateway Device is available for alternate routing (false condition).
Flashing 5 times per sec.:
The device has established direct connection to a single Gateway Device.
Flashing 2 times per sec.:
The device has established connection to a Router Device, and at least one
more Router Device is available on the same hop level, as an alternate route
(redundant connection).
Flashing 1 sec. on / 1 sec. off: The device has established connection to a single Router Device, and no
alternatives exist on the same hop level.
No light:
The device is disconnected.
Middle LED (green): Received signal strength (RSSI)
Flashing 5 times per sec.:
RSSI is very good.
Flashing 2 times per sec.:
RSSI is good.
Flashing 1 sec. on / 1 sec. off: RSSI is acceptable for reliable communication.
Flashing 2 sec. on / 2 sec. off: RSSI is not acceptable for reliable communication.
Bottom LED (red): Indicates initialization
Flashing 5 times per sec.:
The module is not initialized correctly. In this case you have to press for more
than 2 seconds the push button, in order to re-initialize the module.
Flashing 2 times per sec.:
The module is working properly.
Button functionality
Short press:
A status message will be issued to the gateway device of the wireless network.
Press more than 2 sec.:
The router module will restore to its factory default settings. This is extremely
useful in case of an error setting during wireless network installation.
ProLED
OvaLED/OmniLED/AeriLED
UniLED
OvaLED/OmniLED Spot
AgoraLED
GB
