WH00X30418
Part Install Instructions
Overview
– Procedure for programming new Main Boards when
all LED’s are flashing.
WH22X29532, WH22X30898
UltraFresh™ Washer Main Board
!
IMPORTANT SAFETY NOTICE
The information in this part instruction is intended for use by
individuals possessing adequate backgrounds of electrical,
electronic and mechanical experience. Any attempt to repair a
major appliance may result in personal injury and property damage.
The manufacturer or seller cannot be responsible for the
interpretation of this information, nor can it assume any liability in
connection with its use.
!
WARNING
To avoid personal injury, disconnect power before servicing this
appliance. If electrical power is required for diagnosis or test
purposes, disconnect the power immediately after performing the
necessary checks. RECONNECT ALL GROUNDING DEVICES If
grounding wires, screws, straps, clips, nuts, or washers used to
complete a path to ground are removed for service, they must be
returned to their original position and properly fastened.
Parts Included:
•
Main Board
•
Instruction Sheet
1. Press and release the Start button.
LED’s will stop flashing and the display should show “0”.
2. Press and release the Start button
until the display shows the number of the personality ID
needed.
▪
When the end of the ID list is reached the control will wrap around to the beginning of
the personality ID number list.
3. Press and hold the Start button for three seconds
when the correct personality ID number
needed is in the display.
▪
This will save the personality ID number and the control will go to an idle state.
NOTE:
If an error is made programming the Main Board or the LED’s are not flashing, enter Field
Service Mode as shown on the last page of these instructions. Use service mode test 17 to enter
the correct personality.
1
GFW650SPN0**
3
GFW650SSN0**
3
GFW850SPN0**
4
GFW850SSN0**
4
