KTS-250-16 Video Distribution Amplifier
1036614B / February 2003
Technical Support: 800-469-1676
1
This unit distributes up to 16 composite video signals to multiple isolated outputs. Its input/output channels are internally
organized into eight pairs (see Figure 1).
Figure 1. Input/Output pairs
Each pair can be set to function in one of two modes: 2-input x 4-output, which distributes each video input to four
outputs; or 1-input x 8-output, which distributes one video input to eight video outputs (see Figures 2 and 3). All of the
unit’s input/output pairs are preset to be in the 2-input x 4-output mode. If you intend to use this product in 2-input x 4-
output mode, skip the section on
Selecting Modes
and proceed to
Installation
.
Video 1 input Video 2 input
Video 1 input
Video 1 outputs Video 2 outputs
Video 1 outputs
Figure 2. 2-input x 4-output distribution mode
Figure 3. 1-input x 8-output distribution mode
S
ELECTING
M
ODES
1)
Unscrew the cover screws on the top and bottom of the unit (see Figure 4).
2)
Remove the front cover.
Figure 4. Remove cover screws on top and bottom of unit
3)
Locate the mode selector switches on the circuit board (see Figure 5).
Note:
When you are looking at the circuit board from the front, the mode selector switch on the far left controls input/output channels 15 and 16,
and the mode selector switch on the far right controls input/output channels 1 and 2.
4)
Slide each switch so that it lines up with the appropriate mode, 1 x 8 or 2 x 4 (See Figure 5).
5)
Reinstall the cover and the cover screws.
