ATS1160/1161 Mifare bus reader
Installation instructions
Revision 2.1 (October 2008)
•
Part number 1063986
EN
FR
NL
IT
PL
PT
NO
ES
DA
SV
DE
FI
www.gesecurity.eu
•
Copyright © 2008 GE Security B.V. All rights reserved
EN
Mifare bus reader
The ATS1160/1161 Reader is a Mifare card reader (compatible with
the GE
Security cards ACT406/ACT407/ACT408/ACT430). It is
designed, for example, to mount on metal, window or door frames
and is suitable for any location that requires a small reader.
The ATS1161 is equipped with a keypad for Card+PIN applications.
The ATS1160/1161 incorporates all interface electronics necessary
to interface with the ATS control panel bus and the ATS 125x local
bus.
It is configurable through a Menu system accessible via a bus LCD
RAS or the ATS1482 Programming card.
The reader operates from 10.8 to 30 VDC.
Both the ATS1160 & ATS1161 are waterproof.
Mounting
The reader can be mounted on any flat surface by two pan head
screws, 3.0-3.5 mm diameter, located under the cover. A slightly
reduced range will be experienced when mounted on metal
surfaces.
It is not recommended to use countersunk screws.
If readers are placed closer than 10 cm from each other or if the
reader is installed on metal, the reader distance can be shorter.
Do not install close to sources of powerful electromagnetic
disturbance.
Do not cut the cable shorter than 10 cm.
RAS Addressing
The address of the reader for bus operations is set to the default
address RAS 16. You can change it using a configuration card or
accessing its online menu system when connected to the RS485
bus.
It is possible to change the reader address with
configuration card only when the reader is not polled.
Tamper
The reader is provided with a tamper facility. When connected to
the bus, tamper data is transmitted to the Advisor Master with
system data.
Reader Menus
Enter via the Installer menu and select the menu “Remote
Devices”, then select “RAS”.
The following options are available:
1.
Tamper option: Enable/disable (default enabled).
2.
Reader Address: Changing reader address (1-16),
default = 16.
Reader Wiring
Red:
+12V
Positive 10.8 to 30 VDC supply, 150 mA
Black:
0 Volts
DC supply ground
Green:
D -
RS485 Data -
White
D +
RS485 Data +
Spare wires are not used.
Use WCAT54 cable. Cable length depends on the bus
configuration.
Reader LEDs
Led
pos.
Colour
Description
Green System
disarmed
Orange System
armed
Left
Green flashing
Access granted
Middle
Orange
System not ready
ATS4000
Right Red
flashing Alarm
Green System
disarmed
Red System
armed
Green flashing
Access granted
Left
Red flashing
Access granted during alarm
Middle Orange
Always
on
ATS125x
Right Red
flashing Alarm
Technical specifications
Supply voltage ................................................................................. 10.8 - 30 VDC
Current consumption .................................................................... 130 mA max.
Material of design housing .......................................................................Plastic
Dimensions of housing (H x W x D)................................ 140 x 44 x 20 mm
Operating temperature ................................................................ -40 to +55 °C
Storage temperature..................................................................... -40 to +55 °C
Protection class...................................................................................................IP67
Cable ............................................................................................................... LIYY 2 m
Connectivity ...................................................................RS485 data bus device
Addressing...............................................................Via keypad or config. card
