1
Model No.: DCS-45
User’s Manual
Ⅰ.
Introduction
The DCS-45 camera housing is built using die-cast aluminum, powder coated and stove
finished. The design and manufacture is adapted to the highest technical standard with IP
66 level of environmental protection. The housing is provided with an adjustable semi-cable-
managed mounting bracket.
(D)
(E)
(F)
(K)
(G)
Fig.1
(B)
90
°
90
°
78
65
(H)
Fig.2
Inner space for camera mount
W90 x H70 x L230mm
1. Use the rear section of the
mounting bracket
(D)
as a template for marking the position of the
mounting holes
(H). Remove and drill the holes
accordingly.
2. Attach the mounting bracket arm to the wall using
the rawlplugs and screws provided.
3. Attach the
main housing enclosure
(K) to the
mounting bracket with two of 1/4” x 14.7 mm
trilobular screws
(F) provided.
4. Release
screw
(E) on the mounting bracket to pan
the housing and then release
screw
(G) to tilt the
housing. Position the housing as required for the
correct camera coverage and then securely tighten
the screws.
5. Feed cables through the
cover plate
(B) of the
mounting bracket from the wall, or by using cable
conduits.
Ⅱ.
Mounting configuration of DCS-45
