Assembly
(
STEP 1, FIG. A &B
) Locate the black spray wand holder shown in
figure A and attach it to the inside of the Brush and Roller Cleaner as
shown in figure B.
(
STEP 2, FIG. C
) Feed orange tube down through hole in top of
cleaner and into spray wand holder.
(
STEP 3
) Attach the orange clip to the hose. Note: The clips acts as a
storage area for the adaptor and hose when not in use.
Catalog No.
BRC300
CAT. NO. BRC300 FORM NO. 640297-00 (APR- 06) COPYRIGHT © 2006 BLACK & DECKER PRINTED IN CHINA
VEA EL ESPAÑOL EN LA CONTRAPORTADA.
INSTRUCTIVO DE OPERACIÓN, CENTROS DE SERVICIO Y
PÓLIZA DE GARANTÍA.
ADVERTENCIA:
LÉASE ESTE
INSTRUCTIVO ANTES DE USAR EL PRODUCTO.
INSTRUCTION MANUAL
B
B
B
B
R
R
R
R
U
U
U
U
S
S
S
S
H
H
H
H
&
&
&
&
R
R
R
R
O
O
O
O
L
L
L
L
L
L
L
L
E
E
E
E
R
R
R
R
C
C
C
C
L
L
L
L
E
E
E
E
A
A
A
A
N
N
N
N
E
E
E
E
R
R
R
R
SAVE THIS MANUAL FOR FUTURE REFERENCE.
Important Safety Instructions
WARNING!
To reduce the risk of injury, user must read and understand instruction
manual.
•
Read all instructions before using the Brush and Roller Cleaner.
•
Always wear proper eye protection.
•
Always use proper drainage, test the drain with running water before attempting to use the
Brush and Roller Cleaner.
•
Local disposal requirements vary; consult your sanitation department or state designated
environmental agency for disposal options.
•
Do not use hot water. It will not decrease the cleaning process and can damage the roller
sleeve.
•
Do not use with oil based paints. Brush and Roller Cleaner can only be used with latex
water based paint.
•
Brush and Roller Cleaner should only be connected to a water supply with standard
household water pressure.
SAVE THESE INSTRUCTIONS
Cleaning Brushes:
(
STEP 1
,
FIG. 1
) Remove the aerator from
your faucet and replace it with the faucet
adaptor.
(
STEP 2, FIG. 2
) Place the Brush and Roller Cleaner
into the sink and attach the hose to the faucet.
(
STEP 3, FIG. 3
) Remove any excess paint from brush
by scraping bristles on side of paint container. Insert
brush handle into brush holder.
(
STEP 4, FIG. 4
) Remove the cap and insert brush into
canister, with paint brush icon pointing toward spray
control knob.
Place top cap into position on the canister.
(
STEP 5, FIG. 5
) Turn on faucet part way and check for
leaks, then turn on faucet to full.
(
STEP 6, FIG. 6
) Direct the spray to the center of the
brush, saturating the bristles with water.
(
STEP 7, FIG. 7
) Direct the spray to the edge of the
brush, spinning brush to remove paint.
•
Repeat steps 6 & 7 until water runs clear.
Cleaning Rollers
(
STEP 1,FIG. 8
) Remove the aerator from
your faucet and replace it with the faucet
adaptor.
BEFORE RETURNING THIS PRODUCT
FOR ANY REASON PLEASE CALL
1-800-544-6986
BEFORE YOU CALL, HAVE THE CATALOG No. AND DATE CODE AVAILABLE. IN MOST CASES, A
BLACK & DECKER
REPRESENTATIVE CAN RESOLVE THE PROBLEM OVER THE PHONE. IF YOU HAVE
A SUGGESTION OR COMMENT, GIVE US A CALL. YOUR FEEDBACK IS VITAL TO BLACK & DECKER.
T
T
HANK
HANK
YOU
YOU
FOR
FOR
CHOOSING
CHOOSING
B
B
LACK
LACK
&
&
D
D
ECKER
ECKER
!
!
G
G
O
O
T
T
O
O
WWW
WWW
.B
.B
LACKAND
LACKAND
D
D
ECKER
ECKER
.
.
COM
COM
/N
/N
EW
EW
O
O
WNER
WNER
T
T
O
O
REGISTER
REGISTER
YOUR
YOUR
NEW
NEW
PRODUCT
PRODUCT
.
.
1
2
3
4
5
6
7
Operating Instructions
8
FEATURES
A. Cap
B. Spray control knob
C. Faucet adator
D. Hose
E. Roller frame holder
F. Brush holder
G. Spray wand holder
A
B
C
C
D
E
F
G
A
B
C
